Readers ask: How To Tile Around Pipes?

Readers ask: How To Tile Around Pipes?

Can you tile behind pipes?

Firstly, you ‘ll need to tile up until the point you reach your pipe. Remove every fitting you can possibly remove to make tiling far easier. If you ‘re tiling from one side of a room to another, you ‘ll reach the pipe likely from either one side or from below the pipe.

Do you grout around pipes?

As above said, don’t grout around pipe, just fit a collar so pipe has movement.

How do you tile around a curve?

Lay a piece of paper on the surface around the curve. Mark and cut away the paper until it fits around the curve as the tile should. Lay out your tiles and then lay the piece of paper on top. With a pencil, mark the tiles around the edge of the paper curve.

How do you cover gaps around pipes?

Apply caulk or expanding foam around the hole. If the gap around the pipe is wider than an inch, use a solid material like sheet metal, plywood, or rigid foam to fill the hole.

Can you grout around copper pipes?

The answer is that tile grout seems to be very inert and does not normally corrode copper pipes.

You might be interested:  Readers ask: How To Get Tile Glue Off Hardwood Floors?

How do you seal plumbing pipes?

You apply epoxy directly onto the leaking pipe, like you would with caulk or plumber’s putty. The epoxy will temporarily form a seal over the leak. Clamps and wraps are even simpler; you just affix or wrap them around the leak, and they hold in the water until you can get the pipe replaced.

Should I tile behind my toilet?

The bathroom fitters are unanimous—if you’re looking for a high quality finish, with a better seal against water damage, then always tile the floor first. The floor will be sealed a lot better with the tiles being laid under the toilet. 2. It is also easier to do this rather than trying to cut tiles around the toilet.

Do you tile under or around toilet?

To install tile properly around the toilet, you need to affix it to the floor under the fixture. Because toilets sit on top of tile, any rough cuts are hidden, making it easy to achieve the appearance of tile that has been custom-cut for your bathroom.

Should toilet flange sit on top of tile?

The toilet flange needs to be on top of the finished floor. Meaning the bottom edge of the flange needs to be on the same plane as the toilet. So if your toilet sits on the tile, the flange needs to be on top of the tile too. The spacing of the toilet exit “horn” and sealing surface is designed for this height.

Should I drill between tiles?

If not done correctly, the ceramic tiles can crack, and the grout can crumble or break away. Grout isn’t as stable and strong as tile, and drilling into grout isn’t recommended.

You might be interested:  Readers ask: How To Finish Tile Edge On Wall?

Can I use masonry drill bit on tiles?

As mentioned earlier, drilling through tile requires a specialist drill bit – regular or even masonry bits simply won’t do the job as they’re not strong enough to penetrate tiles ‘ hard surfaces. Instead, you should opt for either carbide-tipped or diamond-tipped drill bits.

Leave a Reply

Your email address will not be published. Required fields are marked *