Quick Answer: How To Tile A Slate Roof?

Quick Answer: How To Tile A Slate Roof?

When tiling a roof where do you start?

Start on one edge of the roof and fix with two or three nails then roll out the roofing membrane or felt keeping it taught but with a very slight hint of sag, this will ensure any water that does end up on the felt will run between the rafters and end up in the gutter.

How much should slate tiles overlap?

Side lap gap – The gap between abutting slates should be between 1 – 5mm, most people these days quote 3mm, up to a maximum of 9mm for fibre cement slates.

Can you stand on a slate roof?

Though slate roofs are durable, over time they tend to deteriorate. You must not walk on a slate roof under this condition. If you see a broken slate on the roof, do not try to fix it yourself. If you try to repair the slate roof by your own hands, there are chances of massive damages to your roofing structure.

You might be interested:  How To Lay Tile Flooring In Kitchen?

What is the overlap on slates?

The top of the slate is referred to as the ‘head’. Overlap is when one slate overlaps another, whereas ‘head lap’ is when the head of a slate is overlapped by the slate two courses above it.

How much does it cost to install a tile roof?

Tile Roof Cost The cost to install a tile roof averages $15,398, with a typical range of $7,895 and $23,299. Homeowners can expect to pay $8 to $25 per square foot. This breaks down to $2 to $10 per square foot for materials and $5 to $18 per square foot for installation.

How much Batten do you need for a slate roof?

In most cases, irrespective of rafter spacings, 50 x 25mm battens should be used for our standard preholed fibre cement slates. Where BS 5534 suggests 38 x 25mm battens are acceptable, the slates should only be laid with 100 or 110mm lap.

Which is better slate or tile roof?

Tiles are generally larger than slates and can ‘interlock’ which makes them easier to install. However for roofing that features a skylight or multiple chimney points, smaller tiles may be needed to better fit the roofing structure.

What pitch can Slate go down to?

Because of this, the general recommendation for slate is a 20° pitch angle. There are some circumstances in which slate roofs can have a minimum pitch as low as 17.5°, but this depends on the type of slate being used, the size of the lap, and some other factors.

What is the minimum pitch of a slate roof?

Conventional low pitch slate roofs are recommended down to a minimum of 20° in areas of sheltered or moderate exposure, providing a 500x300mm slate is used and a headlap of 115mm. Higher exposure or different sized slates necessitated a greater roof pitch of 22.5° or more.

You might be interested:  Question: How To Tile Outdoor Steps?

How do you fix ridge tiles on a slate roof?

Use a solid bed of mortar at the ends of ridge tiles to fill the gap where they met (see picture below), use a piece of flat tile slip (or slate ) to bridge the gap between the tops of the slates / tiles on either side and to support the mortar which fills the gap underneath and between the ridge tiles.

How do you walk on a slate roof?

Secure the rags and towels into place as you work by fastening them with bungee cords or nylon zip ties. Continue wrapping and tying until the flat sides of both uprights have been completely protected with towels and rags. Slate roofing tiles are very delicate and can easily crack and dislodge under your weight.

How do you protect a slate roof?

Clear protective roof sealer to provide lasting protection to all types of roof tiles. Our roof sealer will protect porous clay, slate and concrete roof tiles by making them water resistant.

How much do Slate roofs cost?

The average roofing installation price for a slate tile roof costs anywhere between $11,550 to $24,000 depending on the slope, pitch, and size of your home’s roof. You can expect to pay $9 to $16 per sq. foot or $900 to $1,600 per square installed on a standard sized single story home.

Leave a Reply

Your email address will not be published. Required fields are marked *